Postby Petrified.Rabbit » Tue Feb 22, 2011 10:49 pm
i was actually going to buy those for my ae86, but decided i would stick with old school and no body kit..
if you do 15x7 in front you will be just past flush (10mm), i would say a little stretch?? but your talking tire from bfi..
in the back i "think" you will be fine. im running a +10 mm offset, with some 1/4 work. pulling the in 15mm would only mean they fit better, right? but unless you want to roll/pull your 1/4 i cannot guarantee a fit..
here is what i do.. do you have a 90* angle? (piece of card board would work). ( i have an old L square) put it against the hub, with the L coming out at the wheel well top.. mark the inches of space you have before you hit the lip of the car..
on a 7" rim, the is 3.5" to center (0 offset), so converting 3.5" to mm by multiplying by 25.4 = 88.9mm
88.9mm is center of the tire mounting surface (7" advertised rim)
since you have a +25 offset. you have 63.9mm face ( 88.9-25= ) and a 103.9 rare (88.9+25=) spacing..
your more worried about the face.. 63.9 mm divided by 25.4 = 2.516" out from the hub..
but remember, a 7in rim is actually 7 3/4"-8" wide lip to lip.. so you have @ 3" from the face of the hub to the edge of the rim.
so put a true 90 on the hub and if you have 3" clearance, the rims will fit. i could offer to help. but my car is pulled for 10mm offset..