impact gun

Post you HOW-TO and DIY threads here.
User avatar
one_man_jam
Posts: 169
Joined: Mon Sep 14, 2009 11:08 am
Location: Flagstaff, AZ

Re: impact gun

Postby one_man_jam » Tue Aug 24, 2010 2:18 am

ooo craigslist :D i'm gonna check right now.

like i said, i want it for regular maintenance and i also just want to save myself some knuckle and forearm bashing in the future.

UR Canada goodies installed and available here http://ultraracingcanada.com/?q=catalog/27
ImageImage

User avatar
Monzaveo
Posts: 56
Joined: Mon Sep 14, 2009 8:35 am

Re: impact gun

Postby Monzaveo » Wed Aug 25, 2010 8:20 am

I'd use a breaker bar on the Crank pulley..

Will the vibrations from the impact affect the bearings?? Thats what I was worried about.

My Hitachi impact..18v will Almost remove Lugnuts. They usually need a start with a tire iron.

It will tighten them up nearly 100% though.

User avatar
Petrified.Rabbit
Posts: 1254
Joined: Sat Sep 12, 2009 12:08 am
Location: Pittsburgh

Re: impact gun

Postby Petrified.Rabbit » Wed Aug 25, 2010 8:58 am

if you have enough oomph out of the impact the bearings will be fine because the crank wont move, the bolt will just unthread.

but if its not turning out, and your just vibrating on the impact hammers (know what i mean?) then the jerking motion could potentially wear the bearing funny since its rocking in the wrong direction.. but even though the impact does have more power (force) than the combustion stroke, which happens 3200-3400 times per minute during idle., its exerting the same turning force. so the bearings should be ok for the 2 seconds it takes to break the bolt loose.



Return to “HOW-TO / DIY”

Who is online

Users browsing this forum: No registered users and 2 guests