FAQ

User avatar
WOLFMAN AK907
Posts: 1008
Joined: Sat Sep 12, 2009 2:38 am
Location: Fairbanks, Alaska
Contact:

FAQ

Postby WOLFMAN AK907 » Sun Sep 13, 2009 11:49 pm

Radio Removal: viewtopic.php?f=9&t=25&p=98#p98

My factory stereo won't work, is there a code? viewtopic.php?f=9&t=25&p=117#p117

Farthest North Aveo: Fairbanks, Alaska
ImageImageImage

User avatar
WOLFMAN AK907
Posts: 1008
Joined: Sat Sep 12, 2009 2:38 am
Location: Fairbanks, Alaska
Contact:

Re: FAQ

Postby WOLFMAN AK907 » Sun Sep 13, 2009 11:54 pm

On both sides of the radio are trim pieces that extend from the top of the radio down to the bottom of the storage bin (they don't go around the top or bottom. just trying to give you reference point). All you need to do is pry these 2 pieces off. I started at the bottom. I used a screw driver to get underneath the trim piece but that was probably a bad choice of tools since I scratched the grey plastic on the adjoining dash piece slightly (probably only noticeable by me). Once you get these 2 trim pieces off the hard work is done. Next it's a matter of removing the 4 screws holding the radio/storage bin assembly in. These screws should be obvious to you. Now the radio/storage bin assembly can be removed. Unplug the wiring harness and antenna. Now remove the screws that fasten the radio to the storage bin. It really only took me about 5 minutes to get the old radio out. For the installation I used a wiring harness which cost me $10. You should definitely get one. As far as mounting the new radio, I re-used the storage bin/radio assembly. All I had to do was enlarge a couple of the holes in the factory mounting assembly because the new radio mounting screws were of larger diameter. You'll also notice that on top of the storage bin there are a couple of nubs that fit into the factory stereo. I had to remove these. I used a wood chisel. You could probably use a utility knife or figure something else out. Just be careful to stay away from the front edge so you don't mar any plastic that will show. If you so choose you can buy an aftermarket stereo dash-install kit, but the stock one works fine. One last note, you will need to use the trim piece that goes around the face on the new radio.
Farthest North Aveo: Fairbanks, Alaska
ImageImageImage

User avatar
WOLFMAN AK907
Posts: 1008
Joined: Sat Sep 12, 2009 2:38 am
Location: Fairbanks, Alaska
Contact:

Re: FAQ

Postby WOLFMAN AK907 » Mon Sep 14, 2009 1:32 am

My factory stereo won't work, is there a code:
Yes, sometimes there is a code to activate an OEM car stereo. You can get the code at your dealer, but try these codes first to possibly save yourself a trip.
1156, 3116, 3451, 2152, 4362, 4316
4316, 2152, 4513, 4362, 1156, 2145
6451, 6361, 5624, 5241, 3346, 1165
3241, 4524, 5436, 5813, 3265, 7348
2453, 3462, 3251, 5445, 8253, 2253
2346, 4853, 6645, 5253, 1325, 4136
3116, 3221, 2151, 5312, 2654, 4315

Farthest North Aveo: Fairbanks, Alaska
ImageImageImage


Return to “Audio / Video”

Who is online

Users browsing this forum: No registered users and 12 guests