what did they charge you to put them in?
lanos cams
- thehunterooo
- Posts: 944
- Joined: Sat Sep 12, 2009 11:33 pm
- Location: Tampa, FL
Re: lanos cams
nice, just what i need
what did they charge you to put them in?
what did they charge you to put them in?
http://www.facebook.com/#/profile.php?ref=name&id=100000185677338
http://www.cardomain.com/ride/3124271
http://www.cardomain.com/ride/3124271
Re: lanos cams
Dun think prices in singapore can be compared to the States.
But if i convert the price, i guess i was charged around US$120 on labour just for changing the cams alone.
A re-tune from the same tuner would cost another US$100~120 as well.
I guess its should be kinda ex, but hey...4 bangers are more in market here compared to IL6, V6 or even V8.
But having some problems lately, the vacuum reading goes very low sometimes especially after turning on the air-con. Stepping on the gas would cause the compressor to cut off earlier than normal.
There are times during idling, where it would go dip to 500rpm and back up to 750rpm, engine didnt stall tho.
I suspect it could be the tuning is kinda lean.
But if i convert the price, i guess i was charged around US$120 on labour just for changing the cams alone.
A re-tune from the same tuner would cost another US$100~120 as well.
I guess its should be kinda ex, but hey...4 bangers are more in market here compared to IL6, V6 or even V8.
But having some problems lately, the vacuum reading goes very low sometimes especially after turning on the air-con. Stepping on the gas would cause the compressor to cut off earlier than normal.
There are times during idling, where it would go dip to 500rpm and back up to 750rpm, engine didnt stall tho.
I suspect it could be the tuning is kinda lean.
- thehunterooo
- Posts: 944
- Joined: Sat Sep 12, 2009 11:33 pm
- Location: Tampa, FL
Re: lanos cams
yeah, it wasnt tuned right, it is just a bit off
http://www.facebook.com/#/profile.php?ref=name&id=100000185677338
http://www.cardomain.com/ride/3124271
http://www.cardomain.com/ride/3124271
Return to “Engine / Drivetrain”
Who is online
Users browsing this forum: No registered users and 11 guests