Thehunterooo's Aveo

[thehunterooo]

lol yup, the extra space was worth it though, plus the pipe was not long enough, and the filter still is not on all the way, so i really had no choice in the matter, which is the main reason i have not bought a bypass, i will have to run into a foot deep of water to have any chance of trouble

[thehunterooo]

the tach works!!!

replaced the leds in my gauge after the two were duds, and found that one i put in is another dud, so im just going to leave it in there for a while

too damn hot though, the strut bar is on hold again lol, 95 degrees is too much for me :P

[AveoSwagg09]

95 is chilly in Florida. lol.

[thehunterooo]

[thehunterooo]

the bolts are too big for the holes for the strut bar, and a bolt ended up falling behind the ecu so it is a no go until winter, nothing seems to work out lol, i am taking a long break

[serega12]

you're funny, dude. Did you at least get that bolt out?

[MetroMPG]

Come up here! It's only about 87. Less humid though.

I was messing around today cutting rusty bits out of a floor pan. I'll save the welding for later though, when it's winter.

[thehunterooo]

bolt fell behind the ecu, the one that larsbud had to grind off to fit the bar, i could not get it out as it looks like there was one more bolt at the bottom, i wish i had a place to work at but outside on an open concrete slab is not ideal, and people always look at me like im crazy its 97 out right now btw

next day i have off i think ill go to lowes and get smaller hardware and get it down, its a piece of cake if the bolts fit right

i think this week ill send that dash piece up to mike for the 52mm gauges

[serega12]

Are you sure you wanna go with a smaller bolt for this application? if it snaps off it will hit the tire, bounce, and get stuck in the rear wheel or something..

[thehunterooo]

lol not that smaller, just enough where i can get the bolt through the hole, there is no way those two that came with the bar are fitting in, unless i increase the size of the hole