•  
    Results 1 to 8 of 8

    Thread: 2007 engine codes tb or tps?

    1. #1
      What's wrong with my car?
      Join Date
      Oct 2014
      Location
      Ontario
      Posts
      3
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts

      2007 engine codes tb or tps?

      Hello!

      Im im new to the forum. Just purchased a 07 aveo it hardly runs.

      it has codes
      p2122
      p2106
      p2110
      p2135
      p2101



      I tried cleaning the throttle body it wasn't that gummed is it the pedal? (Tps)

      please help!

      also any other known problems? Or things I should do?

      looking forward to driving. My car has 180k



    2. #2
      What's wrong with my car?
      Join Date
      Oct 2014
      Location
      Ontario
      Posts
      3
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Hello I really need help guys

      I cleaned the throttle body but now i have these faults. .

      ------------------
      P2106: Throttle Actuator Control System - Forced Limited Power
      P2110: Throttle Actuator Control System - Forced Limited RPM
      P161B: Unknown code - More information may be available on the web

      Pending Fault Log
      ------------------
      P2076: Intake Manf Tuning Valve Position Sensor/Switch Circuit Range/Performance
      the

      Please help its been weeks.

    3. #3
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      if you do something wrong when cleaning it, it will set those codes as well.

      it sounds like you must have had power or the key on during the cleaning, the p161B is power loss sensed by the ecm, like disconnecting the battery while running. The other two are fault protections, not codes themselves.


    4. #4
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      all those original codes point to either the throttle body or the pedal. It is more likely that it is the throttle body, how did you clean it?

      the barely running issue isn't necessarily just this as an issue. But if you are stuck in safe mode, you will never figure out if the car runs right or not.


    5. #5
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      the last code, i think is the variable intake, if that hose is leaking, it would let in more air, and throw off some of the intake position depending on how it is being monitored.


    6. #6
      What do you mean there's no turbo?
      Join Date
      Jul 2014
      Location
      Long Island, NY
      Posts
      308
      Thanks
      0
      Thanked 50 Times in 48 Posts
      Possibly a bad throttle body position sensor?
      2004 Aveo beater car
      2005 Aveo LT. 5-speed beater car (DOA)

    7. #7
      What's wrong with my car?
      Join Date
      Oct 2014
      Location
      Ontario
      Posts
      3
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Quote Originally Posted by petrified.rabbit View Post
      all those original codes point to either the throttle body or the pedal. It is more likely that it is the throttle body, how did you clean it?

      the barely running issue isn't necessarily just this as an issue. But if you are stuck in safe mode, you will never figure out if the car runs right or not.
      Hello I took it off and used carb cleaner how do I get it out of safe mode?

      I just put a new tps ( gas pedal) didnt fix any issues cleared the code and p2135 came up again. Thankyou for the help sofar but I Need more advice
      Last edited by Aveo07s; 11-12-2014 at 10:04 PM. Reason: more info

    8. #8
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      try this:

      Procedure 1 Throttle/Idle Learn
      The Idle Learn Procedure listed below must be performed whenever the following occurs:


      •••••
      1.2.3.4.5.6.7.8.
      9.10.
      11.

      The throttle body assembly is replaced
      The throttle body is cleaned
      The engine control module (ECM) is replaced
      The idle air control valve (IAC) is replaced
      Power disconnection (battery cable, ECM fuse, etc.) (Delphi ECM only)

      Turn the ignition ON.
      Turn the ignition OFF for 15 seconds.
      Turn the ignition ON for 5 seconds.
      Turn the ignition OFF for 15 seconds.
      Start the engine in park/neutral.
      Allow the engine to run until the engine coolant temperature is greater than 85°C (185°F).Turn the A/C ON for 10 seconds, if equipped.
      If the vehicle is equipped with an automatic transaxle, apply the parking brake. Whilepressing the brake pedal, place the transaxle in drive (D) for 10 seconds.
      Turn the A/C OFF for 10 seconds, if equipped.
      If the vehicle is equipped with an automatic transaxle, while pressing the brake pedal,place the transaxle in park/neutral.
      Turn the ignition OFF. The idle learn procedure is complete.







    Similar Threads

    1. Chevy Engine Codes (OBD-II scan)
      By tidus10 in forum Engine & Drivetrain
      Replies: 19
      Last Post: 02-21-2020, 06:21 AM
    2. 2004 Aveo Engine Codes...again
      By Sadie in forum General Discussion
      Replies: 4
      Last Post: 10-15-2012, 09:22 PM
    3. Engine codes and definition
      By djmarch in forum General Discussion
      Replies: 1
      Last Post: 03-21-2012, 02:07 AM
    4. Engine error codes
      By gone6 in forum Troubleshooting and Maintenance
      Replies: 4
      Last Post: 06-13-2011, 07:56 PM
    5. New engine in and running but throwing codes
      By fourbi4rox in forum Engine & Drivetrain
      Replies: 20
      Last Post: 04-17-2008, 12:03 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •