•  
    Results 1 to 7 of 7

    Thread: Partial loss of the Secondary information center.

    1. #1
      Should I keep it?
      Join Date
      Oct 2012
      Location
      Gautier, MS
      Posts
      61
      Thanks
      0
      Thanked 0 Times in 0 Posts

      Partial loss of the Secondary information center.

      Hi everybody,

      My 2005 LT Hatch, has a 2007 motor & trans with 80K since the swap (thx DAOX!). New timing belt.
      The SIC seemed to work at random for a while, but is now totally gone. I have the clock and the door ajar light, but nothing else ( CEL, DRL, Airbag indicator, etc...) It would occasionally come back on after I hit a bad pothole or bump (on accident). I'm thinking there is a loose or burnt connector in the wiring harness, but can't find it. I've checked the fuses time and again. they're fine. I'm wide open to suggestions. Maybe a relay? not all of those are labeled on the interior fuse block. Thanks in advance.



    2. #2
      Should I keep it?
      Join Date
      Oct 2012
      Location
      Gautier, MS
      Posts
      61
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Are there wiring diagrams on here? Can't seem to find them.

    3. #3
      Cool Dude.
      Join Date
      Jun 2011
      Location
      Bakersfield, CA
      Posts
      177
      Thanks
      0
      Thanked 0 Times in 0 Posts
      This thread shows a common place where you're going to find electrical mishaps:
      http://www.aveoforum.com/forum/f108/...18/index5.html

      Good luck.

    4. #4
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      If it is strictly limited to only the cluster, (read above post link) I think it is more likely the unit than the harness.
      IF one thing in it is working and nothing else, the wiring to the unit is intact (plugged in at least). You might just need a cluster. But i would use the above post and go through that link and check those spots very well on your car first.


    5. #5
      Should I keep it?
      Join Date
      Oct 2012
      Location
      Gautier, MS
      Posts
      61
      Thanks
      0
      Thanked 0 Times in 0 Posts
      I'll get through it this weekend & be sure to post the results! THANKS GUYS!

    6. #6
      Should I keep it?
      Join Date
      Oct 2012
      Location
      Gautier, MS
      Posts
      61
      Thanks
      0
      Thanked 0 Times in 0 Posts
      The connector / harness referenced in the link above seems fine. No discoloration, smoke damage, melting, etc... I'm an electrician, so I'd recognize those things. Because I had occasionally seen it flicker on when I hit a bump, I have to shy away from replacing the cluster. I just traced the SIC wiring to a relay in the interior fuse block, however impending thunderstorms have me taking cover! As soon as I can get back out there, I'll pull & test that relay. As always, I'll post results & whatever fix works. Still open to ideas, so throw a dart if you'd like!!!!!!

    7. #7
      Should I keep it?
      Join Date
      Oct 2012
      Location
      Gautier, MS
      Posts
      61
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Sorry for the delay. I found that wiggling the connector behind the Secondary Information Center ( SIC ), the lights would flicker. I applied a light coat of di-electric grease to the plug & pins. Problem solved!





    Similar Threads

    1. Information center with clock/front center of dash
      By gonecg in forum Fuel Economy
      Replies: 14
      Last Post: 08-14-2012, 10:00 PM
    2. Any information on where I can get Cv joints??????
      By Hibrydsoul in forum Wheels, Tires, Brakes & Suspension
      Replies: 3
      Last Post: 05-14-2010, 02:50 AM
    3. Information and a Question...
      By xtreme 2 in forum General Discussion
      Replies: 10
      Last Post: 02-22-2008, 09:01 PM
    4. interesting exhaust information
      By AVE0SAM in forum Engine & Drivetrain
      Replies: 6
      Last Post: 02-07-2008, 09:46 PM
    5. e3 plug information
      By y2dgone in forum Engine & Drivetrain
      Replies: 9
      Last Post: 08-01-2007, 08:56 PM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •