Your friend here is the multi-meter. If you have the old parts can you check continuity for each part? That way you can tell if they were the cause of not.
Here is a couple of schematics
earlier version, 2006
![]()
Your friend here is the multi-meter. If you have the old parts can you check continuity for each part? That way you can tell if they were the cause of not.
Here is a couple of schematics
earlier version, 2006
![]()
Please do not power off, firmware update pending.....
I was a little hasty and just replaced the parts (causing a little bit of regret) just to be sure i did check the clutch switch (its the white circle potentiometer type) and i do have a varying resistance. I am not getting power to the signal wire for some reason. Unfortunately im having troube finding pinouts for the circuits leading all the way up to the firewall connector. Also, being a manual do I still have a TCM? Thank you for responding!