•  
    Page 1 of 9 123 ... LastLast
    Results 1 to 10 of 85

    Thread: Strange issue

    1. #1
      Should I keep it?
      Join Date
      Feb 2018
      Location
      Canada
      Posts
      73
      Thanks
      2
      Thanked 1 Time in 1 Post

      Strange issue

      So i have a notorious p0300 code, here is a list of what i have repaired and replaced.

      Plugs and plug wires(plugs gapped to .042)
      Coil(old one was cracked)
      All vacuum lines
      Tightened exhaust manifold bolts(4 were finger tight)
      One wire on ckp harness was broken at engine harness
      Cleaned fuel injectors
      Tightened throttle body(2 upper bolts were loose)
      Replaced egr valve
      Changed timing belt

      Now i have found a broken wire on the harness plug that goes to what i think is the knock sensor, compression is 165 across all 4, would that knock sensor wire cause my p0300? Or is it something worse?



    2. #2
      Almost time to do my timing belt
      Join Date
      Aug 2012
      Location
      Northeast
      Posts
      1,409
      Thanks
      3
      Thanked 103 Times in 94 Posts
      The compression on my ''05 is still over 200 after 12 years, so it's puzzling why yours is quite a bit lower. However, I doubt that would be the cause of the misfire, nor would the detached wire. Do you have a vacuum gauge, or an OBD realtime data stream reader?

    3. #3
      Should I keep it?
      Join Date
      Feb 2018
      Location
      Canada
      Posts
      73
      Thanks
      2
      Thanked 1 Time in 1 Post
      Obd2 live data, vacuum gauge somewhere

    4. #4
      Almost time to do my timing belt
      Join Date
      Aug 2012
      Location
      Northeast
      Posts
      1,409
      Thanks
      3
      Thanked 103 Times in 94 Posts
      What are the fuel trim readings?

    5. #5
      Should I keep it?
      Join Date
      Feb 2018
      Location
      Canada
      Posts
      73
      Thanks
      2
      Thanked 1 Time in 1 Post
      On mine it says frp[psi] and it always states 0.0

    6. #6
      Should I keep it?
      Join Date
      Feb 2018
      Location
      Canada
      Posts
      73
      Thanks
      2
      Thanked 1 Time in 1 Post
      My scan tool is a cheaper one that has the fuel trim reading as CL but in the beginning as i fixed all of the issues it was reading OL

    7. #7
      Almost time to do my timing belt
      Join Date
      Aug 2012
      Location
      Northeast
      Posts
      1,409
      Thanks
      3
      Thanked 103 Times in 94 Posts
      A better OBD reader (Torque App, etc.) may be helpful, but here's a few tests to try.

      Is the misfire causing a noticeable performance problem? If you can hear it stumbling as you rev it up, then try spraying a SMALL bit of carb cleaner into the intake as it's being revved. If it perks up with the extra fuel added, then a fuel pressure test would be the next step. But if adding extra fuel doesn't help, then check what the the vacuum reading is, and also check the spark with a spark tester.

    8. #8
      Should I keep it?
      Join Date
      Feb 2018
      Location
      Canada
      Posts
      73
      Thanks
      2
      Thanked 1 Time in 1 Post
      A chev mechanic may have found the solution, fuel sock on pump is black and clogged

    9. #9
      Almost time to do my timing belt
      Join Date
      Aug 2012
      Location
      Northeast
      Posts
      1,409
      Thanks
      3
      Thanked 103 Times in 94 Posts
      A clogged filter could definitely cause the symptoms you're getting. You might want to investigate what the black stuff is, and try to figure out if there's any more of it still in your gas tank.

    10. #10
      Should I keep it?
      Join Date
      Feb 2018
      Location
      Canada
      Posts
      73
      Thanks
      2
      Thanked 1 Time in 1 Post
      Fuel tank is clean, forgot to mention this car sat for about 3 months prior to me getting it, so my guess is that everything sat at the bottom of the tank and when i got it started it sucked into the pump, which would give the black dirt stuff in the pump.





    Page 1 of 9 123 ... LastLast

    Similar Threads

    1. 2011 Chevy Aveo A/C - Strange Issue
      By BScott in forum Troubleshooting and Maintenance
      Replies: 1
      Last Post: 04-08-2016, 07:13 PM
    2. Oil cap leak, STRANGE!
      By BabyBlue2010 in forum Engine & Drivetrain
      Replies: 8
      Last Post: 12-09-2013, 04:13 PM
    3. something strange.
      By Andrewkittens in forum Troubleshooting and Maintenance
      Replies: 0
      Last Post: 07-27-2012, 09:05 AM
    4. 2005 Aveo Sedan has a strange brake issue and a clunk in the rear right side?
      By Aveo2005 in forum Troubleshooting and Maintenance
      Replies: 2
      Last Post: 08-09-2011, 06:58 PM
    5. Strange Noise
      By in forum Engine & Drivetrain
      Replies: 4
      Last Post: 06-12-2010, 11:02 PM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •