•  
    Results 1 to 4 of 4

    Thread: 2009 shift equalizer adjustment

    1. #1
      What's wrong with my car?
      Join Date
      Jun 2018
      Location
      Eaton Rapids
      Posts
      2
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts

      2009 shift equalizer adjustment

      I'm working on an 09 5 speed. Replaced the shift equalizer and now trans won't go into reverse or neutral. Also (with engine NOT running) without depressing clutch I can move shift lever to any gear position.
      HELP PLEASE

      Thanks



    2. #2
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      the bolt on the end of the rod at the firewall is the adjustment point. I would verify the transmission is in reverse, then loosen the adjustment bolt, and move the shifter to reverse. Make sure the transmission did not shift! Then tighten the bolt and check the gears.. If anything it will be close enough but sloppy.

      Turning the two rods around the axis are the side to side adjustment, sliding the rods in and out are the forward reverse movement.

      For future reader: I marked mine with a piece of tape to mark depth of the connection and then drew a line in the tape to set the axis placement. It was 90% there when reconnected, but still needed some adjustment to be perfect. (although I installed a 30% shorter throw)


    3. #3
      What's wrong with my car?
      Join Date
      Jun 2018
      Location
      Eaton Rapids
      Posts
      2
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Thanks man, I appreciate the help. I found out it was missing the rod too, so that didn't help lol. I've never done this on an Aveo so I didn't know what all was supposed to be there.

    4. #4
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      they are all important. If the shifter is still sloppy one of the best things you can do is replace the weird drop in pin with the T clip on it with a bolt and washer. I forget the exact size that is proper fit 3/8? maybe. but it tightens up the shifter a lot.






    Similar Threads

    1. 2009 radio and fan out, wouldn't shift, now won't start
      By Sag in forum General Discussion
      Replies: 2
      Last Post: 01-26-2016, 12:29 AM
    2. Shift Linkage Adjustment
      By robdot in forum How-To
      Replies: 2
      Last Post: 09-03-2015, 11:53 AM
    3. Valves - 2005 Chevy Aveo - adjustment specs 1.6L valve adjustment
      By Kirby in forum Troubleshooting and Maintenance
      Replies: 7
      Last Post: 06-11-2014, 10:37 PM
    4. Headlight Adjustment 2009 Aveo
      By brewster in forum How-To
      Replies: 4
      Last Post: 05-08-2013, 05:29 PM
    5. Replies: 3
      Last Post: 05-16-2012, 02:00 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •