•  
    Results 1 to 6 of 6

    Thread: Update Time

    1. #1
      Should I keep it? kdr315's Avatar
      Join Date
      Jan 2015
      Location
      Rome, NY United States
      Posts
      84
      Thanks
      34
      Thanked 0 Times in 0 Posts

      Update Time

      Ok, so here is the deal. Somewhere between Monday and today my car seems to be doing pretty well, except for when you go between 40 and 55, this is when the shuddering and shaking and the hold light blinking thing goes on, so is this a good thing? any one have a clue, because I am stumped and I am not a mechanic.



    2. #2
      Still love my daily driver
      Join Date
      Feb 2014
      Location
      pa
      Posts
      800
      Garage empty: add car
      Thanks
      0
      Thanked 11 Times in 11 Posts
      did you check for any codes?

    3. #3
      Should I keep it? kdr315's Avatar
      Join Date
      Jan 2015
      Location
      Rome, NY United States
      Posts
      84
      Thanks
      34
      Thanked 0 Times in 0 Posts
      Quote Originally Posted by camopaint0707 View Post
      did you check for any codes?
      No codes for flashing Hold Light, but when both Engine and Hold light blink it a P0300. Multiple Misfire.

    4. #4
      Still love my daily driver
      Join Date
      Feb 2014
      Location
      pa
      Posts
      800
      Garage empty: add car
      Thanks
      0
      Thanked 11 Times in 11 Posts
      so check the coils, plugs for starters

    5. #5
      Should I keep it? kdr315's Avatar
      Join Date
      Jan 2015
      Location
      Rome, NY United States
      Posts
      84
      Thanks
      34
      Thanked 0 Times in 0 Posts
      Quote Originally Posted by camopaint0707 View Post
      so check the coils, plugs for starters
      They are all new.

    6. #6
      Almost time to do my timing belt xintersecty's Avatar
      Join Date
      Sep 2010
      Location
      West Union, SC
      Posts
      1,687
      Thanks
      86
      Thanked 181 Times in 156 Posts
      Well you have been at this problem for sometime. The wise answer is to not drive 40-55 which is damn impossible.

      So did you go through and check your grounds. This means you take a multimeter and find the ground pin (not shield ground) on the wires going to the coil pack. At then measure the resistance between that connector and the battery terminal. There are two ground on the Aveo 1) To the Starter (duh) 2) and to the frame next to the battery to the right (from front).

      You had mentioned it might be a transmission problem. Did you find out anything there?

      And lastly I wonder if the cams are out of alignment.




      Please do not power off, firmware update pending.....

    Similar Threads

    1. been a while here is an update
      By becausegocart in forum General Discussion
      Replies: 11
      Last Post: 11-27-2014, 12:54 AM
    2. a little update
      By Simple aveo in forum Photographs and Videos
      Replies: 4
      Last Post: 11-27-2013, 08:42 PM
    3. 2005 ECM Update?
      By AndrewButler05 in forum Engine & Drivetrain
      Replies: 2
      Last Post: 10-16-2013, 04:53 PM
    4. Software Update
      By HeavyDuty in forum Troubleshooting and Maintenance
      Replies: 1
      Last Post: 09-15-2012, 07:38 AM
    5. It's been a while, but heres an update.
      By xstevex in forum Exterior
      Replies: 5
      Last Post: 04-07-2007, 08:25 PM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •