•  
    Page 4 of 6 FirstFirst ... 23456 LastLast
    Results 31 to 40 of 51

    Thread: 2005 aveo, check engine light And "Hold" light flashing...

    1. #31
      What's wrong with my car?
      Join Date
      Dec 2012
      Location
      Arkansas
      Posts
      4
      Thanks
      0
      Thanked 0 Times in 0 Posts
      After reading the above comments we checked the plug at the air filter (was told it there was an o2 sensor there) to make sure it was plugged in. they said it wasnt completely plugged in, so did that.... the light didnt stop right then, but about half an hour later the light went off... its been off for over an hour but just hadnt shut the car off til now, so will let you know if it stays off etc.... Other than that is there anything else i should check as well? thank you so much for getting back to me!!!



    2. #32
      Lifetime owner
      Join Date
      Sep 2008
      Location
      Pittsburgh
      Posts
      8,013
      Garage empty: add car
      Thanks
      2
      Thanked 171 Times in 142 Posts
      if the light went out you should be good.


    3. #33
      What's wrong with my car?
      Join Date
      Dec 2012
      Location
      Arkansas
      Posts
      4
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Well folks that is what fixed it! Havent had any more issues with it flashing "hold" or being locked in gear etc.... fuel milage sucks, the o2 sensor behind the catalitic converter went out, and a few quirks, other than that shes back to running right. thank you for all your help!

    4. #34
      What's wrong with my car?
      Join Date
      Oct 2012
      Location
      ohio
      Posts
      15
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Quote Originally Posted by mreid View Post
      I have a 2005 aveo. We just replaced the alternator and now the "hold" light is flashing. we disconnected the battery to reset it, but within a few minutes it was flashing again. Any suggestions? I checked the manual it just says to take it in to be checked. Never had a problem before now. Thank you!!!
      most likely when putting back everything together you for forgot to plug in one of the sensors

    5. #35
      What's wrong with my car?
      Join Date
      Dec 2012
      Location
      Arkansas
      Posts
      4
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Quote Originally Posted by ak1you View Post
      most likely when putting back everything together you for forgot to plug in one of the sensors
      yes, thank you! I posted above that we got it fixed, it was the plug at the air filter... if im correct that has an o2 sensor there. thank you though, i do appreciate any and all advice. have an awesome weekend!

    6. #36
      Should I keep it?
      Join Date
      Feb 2013
      Location
      indiana
      Posts
      45
      Thanks
      0
      Thanked 2 Times in 1 Post
      Hes right. Any time the engine runs sluggish below a certain rpm then the ECU WILL send a signal to the transmission to NOT go into 4th gear so as to not over rev the engine. For me it was a bad Map sensor at $80. My code was #0107. It could be most any code though. A better description of this is on Answers.com under "Flash hold light" page 2.

    7. #37
      Should I keep it?
      Join Date
      Feb 2013
      Location
      indiana
      Posts
      45
      Thanks
      0
      Thanked 2 Times in 1 Post
      You actually mean a Mass Air Flow sensor (MAF) at the air filter box, not a O-2 sensor.

    8. #38
      What's wrong with my car?
      Join Date
      Apr 2013
      Location
      houston tx
      Posts
      1
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Quote Originally Posted by patricklprice View Post
      You actually mean a Mass Air Flow sensor (MAF) at the air filter box, not a O-2 sensor.
      so is it the maf sensor or the O-2 sensor

    9. #39
      Should I keep it?
      Join Date
      Feb 2013
      Location
      indiana
      Posts
      45
      Thanks
      0
      Thanked 2 Times in 1 Post
      No, it was definately the MAP sensor. That part controls allot! I saw it on either E-bay or Amazon where it was $27 each so I bought 2. Thats cheap considering they run around $80 at Auto Zone.
      My situation is different then everyone else here because I have 2- 2005 Aveos LS the same year which allows me to part swap for testing purposes.
      Quote Originally Posted by abeahdeep View Post
      so is it the maf sensor or the O-2 sensor

    10. #40
      What's wrong with my car?
      Join Date
      Oct 2014
      Location
      Dyer
      Posts
      4
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      I too have a Chevy Aveo 05, I am having same issues with the check engine and hold light flashing. now I noticed when the flashing starts I can park and turn off car. when I turn her back on the flashing has stopped and just the check engine light remains. there is misfirings yes but once the car warms up its not as bad. So a friend of mine said it could be spark plugs and also he works at Autozone so he was able to look up some things he printed prices for ignition coil. he said he will start with the changing of spark plugs since I haven't changed them. could be all. My boyfriend thinks the same too about the plugs. could that be the problem





    Page 4 of 6 FirstFirst ... 23456 LastLast

    Similar Threads

    1. Flashing check engine light
      By jimig1 in forum Engine & Drivetrain
      Replies: 34
      Last Post: 12-10-2012, 03:15 AM
    2. Flashing Hold Light
      By timmytaxi in forum Engine & Drivetrain
      Replies: 9
      Last Post: 09-19-2012, 10:27 PM
    3. Check engine light flashing
      By EvySpeedy254 in forum Troubleshooting and Maintenance
      Replies: 11
      Last Post: 01-06-2012, 07:07 PM
    4. flashing check engine light (after full acceleration from a stop)
      By bjorkmae in forum Troubleshooting and Maintenance
      Replies: 3
      Last Post: 07-18-2011, 08:03 PM
    5. Got a flashing "HOLD" on my dash today????
      By redrob in forum Engine & Drivetrain
      Replies: 8
      Last Post: 03-03-2011, 05:17 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •