•  
    Page 1 of 2 12 LastLast
    Results 1 to 10 of 11

    Thread: Car died

    1. #1
      Should I keep it?
      Join Date
      Feb 2015
      Location
      Michigan
      Posts
      40
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts

      Car died

      Hello.

      here goes:

      05 special value 160000

      jist went ahead and replaced:

      MAP sensor
      throttle position sensor
      IAC Valve
      EGR valve
      removed and cleaned throttle body
      tried to replace O2 #1 but rounded off head. May have damaged it
      car ran pretty well before sensor swap ( after cleaning throttle body)
      car ran good after all sensor replacement (about 10 miles on all the equipment..)

      uesterday it just does while running. It cranks fine but will not start.

      Now gives me a P2610 engine ECM/PCM engine off timer performance?

      any ideas as I really need this car??

      thank u



    2. #2
      Should I keep it?
      Join Date
      Feb 2015
      Location
      Michigan
      Posts
      40
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      “It DIED while running.”” Will crank but won’t start

    3. #3
      Should I keep it?
      Join Date
      Feb 2015
      Location
      Michigan
      Posts
      40
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Also timing belt has about 10k on it and all seems good with that

    4. #4
      2004 1.6 Auto Rust Free
      Join Date
      Jun 2019
      Location
      NC
      Posts
      569
      Thanks
      1
      Thanked 59 Times in 55 Posts

    5. #5
      2004 1.6 Auto Rust Free
      Join Date
      Jun 2019
      Location
      NC
      Posts
      569
      Thanks
      1
      Thanked 59 Times in 55 Posts
      And more. Seems to point towards Crank Position Sensor.

      https://www.aveoforum.com/forum/f108...o-start-23154/

    6. #6
      Should I keep it?
      Join Date
      Feb 2015
      Location
      Michigan
      Posts
      40
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Had another ECM programmed and installed..

      car will start and then die a few minutes later leaving me stranded and then it won’t even start again

      Getting that same P 2610 code going to try Crank and cam position sensors tomorrow

    7. #7
      2004 1.6 Auto Rust Free
      Join Date
      Jun 2019
      Location
      NC
      Posts
      569
      Thanks
      1
      Thanked 59 Times in 55 Posts
      Just be aware that once the new sensors are installed, the car may not start until the crank sensor is programmed to the ECU via a Tech2 (GM diagnostic tool) or a different high end tool, Snap on, autell, etc.
      sometimes they work without programming, sometimes they don’t.
      Last edited by Eg.h2o; 12-30-2021 at 03:32 AM.

    8. #8
      2004 1.6 Auto Rust Free
      Join Date
      Jun 2019
      Location
      NC
      Posts
      569
      Thanks
      1
      Thanked 59 Times in 55 Posts
      Any update?

    9. #9
      Should I keep it?
      Join Date
      Feb 2015
      Location
      Michigan
      Posts
      40
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Well first I have to say every new component I put in the car has made a bit of a difference.

      what I did in the past 7 days:

      R&R:

      O2 sensor 1
      EGR Valve
      MAP sensor
      Air Intake Sensor
      Idle Air Control Valve
      Throttle Position Sensor
      Crankshaft Position Sensor
      Used-Reprogrammed ECU.

      Removed and cleaned the throttle body

      Still would crap out and misfire.

      Turns out Rock Auto sold me either the wrong or a defective TPS. Put the old one in and it ran fine but as I say even better than before of course after sinking $100’s in new part’s. Kind of a bitter sweet ending for sure..

    10. #10
      Should I keep it?
      Join Date
      Feb 2015
      Location
      Michigan
      Posts
      40
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Funny thing is, I never got a code for the TPS……





    Page 1 of 2 12 LastLast

    Similar Threads

    1. 2009 Speedo died, rough shifting, CEL on, no cruise HELP
      By 2009-Red-P-O-S in forum Troubleshooting and Maintenance
      Replies: 22
      Last Post: 07-08-2016, 04:24 AM
    2. 2007 Aveo died when pushing in clutch
      By Ttppss in forum Troubleshooting and Maintenance
      Replies: 22
      Last Post: 04-10-2012, 05:06 AM
    3. Car battery died after idling...
      By bjorkmae in forum Troubleshooting and Maintenance
      Replies: 5
      Last Post: 08-02-2011, 01:35 PM
    4. So my car died....
      By petrified.rabbit in forum Troubleshooting and Maintenance
      Replies: 30
      Last Post: 06-18-2010, 05:22 PM
    5. Help Please! Radio died.
      By miketop3 in forum Audio, Video & Interior
      Replies: 7
      Last Post: 03-19-2008, 08:39 PM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •