Chevrolet Aveo 2007 Engine not Running - Please Help

Hi . I have a big problem with chevrolet aveo 2007 ,
I'm form saudiarabia and I changed the engine for the aveo from
the Scraping shop (Second Hand Parts) I bought an used engine for aveo 2010
the first week its worked excellent no problems at all after that
I was driving on the highway and the car turned off the fuel and the heat
pedals goes down and I stopped at the side and i turned the key switch to start and
its not working so I towed it back to the Scraping shop and they fix it
the Mechanical that fix it said its the camshaft sensor getting low Electricity power
and that cause the EMS1 fuse burned , if the engine turned off again
change the EMS1 fuse and its will work again
after 6 days its turned off again and I changed the EMS1 fuse and its worked for 10 second
and its burned again and I change it again and its burned
I asked lots of workshop's and they said they don't know what the problem is
and I didn't change the camshaft sensor because another Mechanical said
the camshaft sensor does not plugged with Electricity
so i don't know what to do

this a image when i insert the key and turned the switch to on
Attachment 4533Attachment 4534

the fuel is full but the pedal is not working

Attachment 4535Attachment 4536

this a image for the engine and the car

http://www.youtube.com/watch?v=_DY36k0tqvk

and this a video when i start the car

please anyone can help me :(

no one knows the problem :S

i havent seen this thread yet, need some help with engine codes etc.. your 2010 engine is nothing like ours, it almost looks like an 08 engine, is that right? is the car dbw or throttle cable? Why did you need the engine in the first place?

if you still have the 08 engine components?

a fuse will not blow because of low voltage. but the lack of supply because of the blown fuse will cause the engine to die.
I would start checking the power distribution for what is blowing the fuse. If the engine was put it, you could have a pinched wire between the engine and bell housing, etc. your mechanic would have pull all the wiring, so something not right could be blowing the fuse causing the problem.

this could, could be as simple of perimeter changes in the senors signal itself. some sensor changes could have been made between model years, and that could be the issue, check part numbers to verify the sensor is acceptable.

hmmm. alot a work to do so yesterday i towed the car to workshop and i changed the engine because the old one is burned :S

i looked at schematic for the ems1 fuse it feeds the anti theft ecm,vehicle speed sensor,high low light relay,abs module,ac relay. It sounds like you have a short or even a bad ground would cause the amps to go up and blow the fuse. Myself i would look for any pinched wires from the engine installation. and check your grounds that fuse feeds alot of circuts. Have your mechanic look up wire schematic