Printable View
I finally finished my oil pressure gauge, and I have to ask... what's a typical reading for an Aveo? At speed it'll run as high as 60 pounds, and at a warm idle it will drop to 20. Is that a normal range, or is the gauge not reading accurately?
I'm also looking to install a vacuum gauge. I have a short ram intake. Do I drill and tap a hole right into the pipe? Any help is appreciated. Thanks!
Toby
A vac gauge goes inbetween the throttle body and the head.
i thought the aveo oil pressure was supposed to be like 40-50 psi, if i remember right from daewootech
most cars drop at idle. but the readings depend on where you mounted the sender, and what not..
is it mechanical or digital?
post pics of your install
The gauges I used are from the Sunpro mini gauge set, which are mechanical. I suspect that the gauge reads low at idle because of the difference in elevation. But anyway. Another member here mounted the same gauges in the center console, and I did the same. I am also putting a dual pod on the top of the dash on the passenger side, which will house an ammeter and a vacuum gauge. Which vacuum line is best for the tee? I'll be working under the car this weekend if it gets warm, so I'll take some pictures around then.
Toby
i meant where in the engine? usually the drop is less between the pump and the oil filter, but the drop could be down to 20 psi if you mounted the pickup line near the head...
Any line between the throttle body and head (mainly the intake manifold). Does not really matter which one.Quote:
Originally Posted by Schwartz1986
I took out the stock pressure sensor on the rear of the engine and put together a tee, so the line is nowhere near the filter. Oh, I need to buy a couple of barbed fittings to splice that vacuum line. Do you know the inside diameter of one of those things?
Toby
STOP, there is a unused vacuum nipple on the right side of the manifold, use that, i did and my vacuum gauge works great