i was wonder about putting a flow master muffler on an 04 aveo and i wanted to put a straight pipe on from after the flex pipe on, i was just wondering if there are any diagrams on the exhaust or can anyone tell me what pieces i need to run it out the back.
Just get a pipe bender, some pipe from home depot (or a store of your choice) take the old one off and bend/weld away to match... You might want to get some flanges though if you want it to come apart. And I would highly suggest at least one straight through resonator to keep the noise out of the car and out the back...
2006 Chevrolet Aveo a.k.a. Holden Barina – SOLD
2008 Chevrolet Cobalt SS/TC - SOLD
ok, my plan with the flanges is just to put them in the original locations, and should i just stick to the stock pipe size or go up in size.
and how much would a pipe bender run me.
Honestly, I have no idea how much it would run you.I just paid the exhaust shop to do mine. They were done in under 45 minutes if I remember correctly. The toughest part for me was deciding which muffler/tip/pipe diameter I wanted to go with. Once that was done - it went very quickly.
2006 Chevrolet Aveo a.k.a. Holden Barina – SOLD
2008 Chevrolet Cobalt SS/TC - SOLD
With crush bends you want 2 1/4" or mandrel bends 2"...Originally Posted by screech985
Any bigger and you will loose too much low end.
I leased Pontiac Wave from September 2006 to August 2011.
and you most likely wont find an actual mandrel bender you will buy just to do your exhaust.. they are $$
i say buy a universal stainless pipe kit with a choice of bends. and weld it together.
Very good point.
I leased Pontiac Wave from September 2006 to August 2011.
ok i was planing on getting the muffler and pipes from summit racing, its like 45 mins from my house, they probably have some sort of universal kit.
they have several, but i am not sure about in a 2" size...
not going to go look for you right now though.
Posting Permissions
LinkBack URL
About LinkBacks
2004 Chevrolet Aveo
Reply With Quote