all i know is they use them on all of the power block shows from tube frames to headers
Printable View
all i know is they use them on all of the power block shows from tube frames to headers
cages and frames but not header. Santiago did a really good segment on Muscle Car about one off headers and used pre-bent mandrel section cut to length.
We may have to continue this topic at my home page, http://www.daftart.com under the 'Group Buys' section but for the time being here is a list of people interested.
there is nothing set in stone, no one is obligated and at this point no money has been collected.
g0ast, 8.5:1, 79.0mm ?
xstevex, 10.5:1, 79.0mm
khan4rtist, 10.5:1, 79.0mm
mikedudley, 8.5:1, 79.0mm ?
AS AN ADDED INSENTIVE... I'll give the Cometic MLS head gaskets at a better than ever price!
.030, .036, .040, .045, .051 and .051 thick...retail price $95.00, DAE price $87.00, WITH PISTONS $75.00
.065 thick...retail price $110.00, DAE price $95.00, WITH PISTONS $85.00
im going for high compression 10.5:1
do you want OE bore or are you going over?
I had a typo on the list... the factory bore is 79mm and the MAX bore is 82mm
hmm.....what would be better? i dont want to have the block machined or anything....
79 it is! :D
what would be a good ratio to run for an N20 set up??
Running Nitrous all the time (WOT Switch) or Single Use?
If I can get some sales going, put me down tentative on the 82mm 8.5:1 pistons...