I need help!

[knucksfirst]

Ok heres the situation. I bought the 3`air intake. Now I need a sleeve made what are the dimensions from the intake... also when i was looking at the hose that goes from the original airbox to the intake theres was a seperate hose coming out of the main one and it went to three other ones which one went to the rad and to the cooland bottle I have no idea what it is. If i get a sleeve made do i have to have that hose attached somehow.. ill try to get a picture. Right now i have the cold air on but its a mess!! I have the original hose going out that at the end i attached an aluminum elbow then the cold air,only problem is the origal hose part bends over and the filter bangs up against the bottom. so i have it all tiewrapped. its bad!!! I have no idea where to go in town to get a proper sleeve made. Plus i have to have that other bottom hose in consideration cause i have no idea what it does. ill post a pic. thank s guys

[serega12]

Is yours a first gen or a second gen (too lazy to look at your other threads right now, but if I remember right it's a first gen engine?)

Anyways, you can remove the whole box and everything under the fender behind the wheel well lines 'cause that's where most of your restriction is, and you don't need it there anymore if you have a cold air intake... (it would get in a way anyways unless you're keeping the filter in the engine compartment, but then it's a hot air intake...