I'm trying to get an oil temperature gauge rigged up, and it's all done except for the placement of the probe. I've completely ruled out drilling into the oil pan, and the oil level sensor has already been used for a pressure gauge. My two options are thus. I could acquire a cross to replace the tee I put on the level sensor, or I could drill through an oil drain plug and thread the probe through there. Has anyone done this before? Having the probe in the drain plug will make oil changes a pain in the ass, and the probe is pretty vulnerable down there. But then, I'm not sure I have room for the cross up top. Has anyone done this before? Any advice is appreciated! Thank you!
That's a neat little gadget! Do you have this thing under your hood? Before I buy it, I want to know for sure that it fits, and that the probe on the Sunpro gauge will fit into one of the four ports.
it was suggested to me by a fella off daewootech, he says he used it on his daewoo... i need it for my car as my oil pressure is off and i need to hook up an oil pressure guage myself. so in that aspect i cannot help you, sorry.
You can not commit crimes in a Aveo. Its just not fast enough.
Alright, one more question. I use the Fram PH3387A oil filter, and that's 18mm by 1.5mm. The adapter you linked me to is 20mm by 1.5mm. Shouldn't I go with the former?
thats because i think some of the daewoos use taller filters than our aveo, u shouldnt have any prob as long as the diameter is the same on the part that screws on where the filter goes. which it is, 1.5 mm. someone plz correct me if im wrong as i dont want to steer anyone in the wrong direction.
You can not commit crimes in a Aveo. Its just not fast enough.
I talked to the tech support folks at Glow Shift, and I ended up ordering the 18mm by 1.5 adapter. Next time I change the oil, I'll see if it all goes together!
LinkBack URL
About LinkBacks
Reply With Quote
Scooby!
