Wheels did not move if in gear, weels did not move in neutral if clutch was not pressed. Slave cylinder seems works well, i asked my wife to press the clutch pedal while i look and i saw the cylinder did it's job. With engine running, i pressed the clutch pedal and put in 3rd or 4th or 5th gear with clutch pedal down, while i release the pedal i feel the clutch working but the weels would'nt move and if i realease the pedal fully the motor dies. It would not engage in 3rd, 4th or 5th if i did not press the clutch. Nothing is is bent outside, i did not had to force anything when removing, replacing and removing again transmission, did not had accident, I carefully inspected transmission, shift link, slave cilynder, everything seems fine, everything move like it should, there is no leak brake oil is clean.
With transmission removed the throwout bearing and finger to slave cilynder moves properly but transmission won't shift in reverse 1st and second gear, it will only engage in 3rd, 4th and 5th speed. The problem seems around there, I believe that nothing should pervent the transmission to engage in gears while transmission is on my bench.
I've found is a little dent on the inside of the clutch componnent and another one on a balancing weight on the new pressure plate that was protuding too far maybe 1/32, i hammered the weight carfully and it should not touch anymore, that explain the few tick that i heard during the first few seconds after starting the motor but not the transmission not turning...