Flasher Relay

My headlight went out and figured while im at it replace the signal bulbs for peace of mind, I put led tail lights in and figured lets do the same for the rear signals (1156A). Thinking it was a direct replacement matching load and everything it wasn't so with less load im stuck with a fast blinker. Instead of throwing the old ones back in or returning them and buying new ones I figured I'd inquire on here if anyone knows if they make a plug n' play solid state/electronic flasher for the aveo?

(could always shove a resistor somewhere to bring it back but popping in another relay sounds neater)

I think the aveo uses the standard 3 prong flasher plug that probably most cars use. I imagine you can get a solid state one.

Thanks I got my hands on one and wrestled the old one out, problem fixed.

I'll leave this bit of info here, I took my old relay apart and much to my surprise it "IS" an electronic flasher. Being dumbfounded why it would go faster with LEDs I looked up the datasheet on the chip and found this

Quote:

---

"Lamp outage is indicated by frequency doubling during hazard warning as well as

direction mode"

---

So it would seem the flasher was designed to act like the ol' flashers of yesteryear when a lamp failed. Could probably trick the chip pulling up the "Lamp failure detection" PIN to trick it for LEDs but it depends if $12 dollars is precious to you to even go through the effort.
http://www.mouser.com/ds/2/36/doc4727-29663.pdf