gauges (pics of the final intall now posted)

[deniswhite1]

ok i desided to install a volt gauge caz i will be pushing 1050 watts RMS, and 150+ leds so keepin an eye on the electrical system would be smart, and a vacuum gauge to improve my gas milege by moding my driving style. i don't have any problems with hookin up the volt gauge, but were do i conect the lil tube for the vacuum gauge in the engine compartment of the aveo

help me out boiz

oh and im picking up trisco gauges it should come out around 60$ for both, and this is what they look like
[attachment=0:2ay63poq]347385_58_full.jpg[/attachment:2ay63poq]

[ontarian_frog]

princess auto

[deniswhite1]

princess auto

what was the point of your reply?

[07_aveo]

princess auto

Are you saying princess auto carries these gauges?

[ontarian_frog]

[quote=07_aveo]

princess auto

Are you saying princess auto carries these gauges?[/quote:17kn6md8]

Yes they do, I work there. Oh An I'll take a pic of my vacuum tube in the engine bay tomorrow.

[deniswhite1]

thanks, what can you tell me about thos gauges? are they ok? do you have em in your car? post pics if you do

[ontarian_frog]

thanks, what can you tell me about thos gauges? are they ok? do you have em in your car? post pics if you do

Yes I do have the vacuum gauge in my car. The gauges are decent. I barely see any comeback that don't work hehe.

[aveodude]

Hook the vac gauge to the intake manifold BETWEEN the head and the throttle body.

[ontarian_frog]

http://i42.photobucket.com/albums/e3...og/p_00121.jpg

The small tube taped to the big one is where I connected the vacuum gauge. I routed the line in the driver side fender to the gauge on the A-pillar.

[deniswhite1]

http://i42.photobucket.com/albums/e3...og/p_00121.jpg

The small tube taped to the big one is where I connected the vacuum gauge. I routed the line in the driver side fender to the gauge on the A-pillar.

so i have to splice in to the big tube? can you post a pics of the gauge on the a pillar, and maybe a close up of the big tube with the conection if its not to hard for ya, did you use a T fiting?

Thanks for your help