opinions on my build

[tony_aveo05]

Okay everyone, ive been on here for weeks now trying to figure out tons of questions. After some time ive come up with these products and have ordered them earlier today.

2 PIONEER TS-B400PRO 4" HIGH EFFICIENCY PRO SERIES BULLET tweeters. these tweeters play from 3.5 khz to 27kh. 200w nom. each (they are sold separately) so a total of 400 nom. there, and 500w max for each or 1000 total w.

a pair of pioneer TS-M800PRO 8 inch midbass speakers. These mids play from 50 hz up to 18kh. They have a total wattage of 700w and 180 nominal.

a component set for the front: DB DRIVE P3 6K 6.5" Pro Audio Midrange Speakers 250 Watts..cant find any info on their nom values.. are these db drive speakers any good? it was hard to find a shallow mount set of speakers for my front doors.

a pioneer MVH-X560BT digital radio. 3 outputs, aux and usb in the back. i got the iphone usb for it so i can be more integrated stuff with the radio.

a pioneer digital GM-D9605 2000 Watt 5-Channel Class FD Car Amplifier. it plays 75w nominal @4 channels, 4ohms. 150W max x 4 chan, @4ohms

1 pioneer TS-SW3002S4 12 inch sub, 1500w max, 400 nom. got the UD-SW300D down firing box for it.

1 pioneer GM-D8601 mono block to power sub. 300 w nom x 1 chan. @ 4ohms

1 PAIR of interfire 2-WAY PASSIVE CAR AUDIO CROSSOVER. plays 200WATSS RMS/400 WATTS PEAK POWER, FREQUANCY RANGE : 40 HZ-25 KHZ, CROSSOVER POINT: 1 KHZ - 2.5 KHZ.

36 sq. feet of dynamat..might as well wrap the whole car.

1......Im slightly concerned with this crossover. The tweets only play down to 3.5 khz, and the xover has a cross over point of 2.5khz. am i going to have an issue meeting the mids with the tweets because of the cross over point??? They are being used for the 8inch midbass with the super tweeter. Should i consider a different xover?

----I am going to see what it sounds like if i set my mid bass/range to play 60 hz all the way up to the 2.5 hz and have my bass play everything from 60 hz down. (are xover's that adjustable? can i set the amount of low bass to the mids?)

Any suggestions on set up?
i plan on putting the db component set in my front panels, the 8 inch woofer and tweeters are going in a custom built rear dash board, and im dynamatting everything. of course the sub is in the hatch.

2.....Anyone see any major problems or sound performance issues with this set up?

Please advise before i start the project. the goods should arrive before the end of next week.

[w00tah]

The crossovers are way too low for the tweets you have. You'd want a set that are crossed in the 4-5khz range or get different tweeters.

2 way passive crossovers are generally a fixed crossover point.

I think if you are dead set at keeping those 8" midbasses, you should build kick panels for them, and run your component set. Run a 3 way crossover, and have the midbass to midrange at 500hz, and the midrange to tweeter at 3khz. Would give you the best sound with the gear you have.

[tony_aveo05]

Yeah i dont think im running any kick panels. I am throwing those in the rear and if it doesn't sound good then i may go with the kick panels.