probably easier to make your own kit
Printable View
probably easier to make your own kit
http://i112.photobucket.com/albums/n...s52efdf7f.jpegQuote:
Originally Posted by metroII
this is the Fog Lamp Wiring Diagram
http://i112.photobucket.com/albums/n...pse6d316fe.jpg
This is Connector X207; its behind the Driver's Side (or Passenger Side for RHD Models) Kick Panel. if you trying to add the Ambient Temperature Sensor for your Driver Information Center, this is the Connector you need to seek because the Pre Wiring done at the Factory Terminates here. and BE CAREFUL, the Wiring for the Front SIR Discriminating Sensors runs through this connector as well.
http://i112.photobucket.com/albums/n...psf68695c7.jpg
this is the Connector Layout of the Underhood Bussed Electrical Center (UBEC) (Ignore the Lines and Numbers on Connectors X1 and X2, those numbers correspond to the Downstream Oxygen Sensor Circuit)
http://i112.photobucket.com/albums/n...ps87463091.jpg
this is the layout of UBEC Connector X2; Pin Number 1 Provides the Control Voltage for the Fog Lamps. the blacked out areas indicate the pins that are not Used.
http://i112.photobucket.com/albums/n...pse7bb3896.jpg
to make finding the Right Wire easier, here is Connector X2's Pinout List.
http://i112.photobucket.com/albums/n...ps6e2a6e12.jpg
This is the Layout of UBEC Connector X3, this is where most of the Fog Lamp Wiring Passes Through the UBEC. the Connector Pins to Single out are Pins 14, 15, and 16.
http://i112.photobucket.com/albums/n...ps1a45ee63.jpg
Connector X2's Pinout List; I've made notes on which Pin and Circuit Does what for the Fog Lamps.
Hope this Helps!
Dude, how tall is your friend? my headlight sits at my knee.. its above his waist.Quote:
Originally Posted by molokaiboi
Lmao he's like 5'5-5'8 or something hahaa. He's 30 but look 14 lmaoQuote:
Originally Posted by petrified.rabbit