probably easier to make your own kit
probably easier to make your own kit
this is the Fog Lamp Wiring Diagram
This is Connector X207; its behind the Driver's Side (or Passenger Side for RHD Models) Kick Panel. if you trying to add the Ambient Temperature Sensor for your Driver Information Center, this is the Connector you need to seek because the Pre Wiring done at the Factory Terminates here. and BE CAREFUL, the Wiring for the Front SIR Discriminating Sensors runs through this connector as well.
this is the Connector Layout of the Underhood Bussed Electrical Center (UBEC) (Ignore the Lines and Numbers on Connectors X1 and X2, those numbers correspond to the Downstream Oxygen Sensor Circuit)
this is the layout of UBEC Connector X2; Pin Number 1 Provides the Control Voltage for the Fog Lamps. the blacked out areas indicate the pins that are not Used.
to make finding the Right Wire easier, here is Connector X2's Pinout List.
This is the Layout of UBEC Connector X3, this is where most of the Fog Lamp Wiring Passes Through the UBEC. the Connector Pins to Single out are Pins 14, 15, and 16.
Connector X2's Pinout List; I've made notes on which Pin and Circuit Does what for the Fog Lamps.
Hope this Helps!