•  
    Page 1 of 2 12 LastLast
    Results 1 to 10 of 12

    Thread: Time for my audio install

    1. #1
      Should I keep it?
      Join Date
      Dec 2015
      Location
      northlake il
      Posts
      34
      Garage empty: add car
      Thanks
      8
      Thanked 1 Time in 1 Post

      Time for my audio install

      Okay so im going to be running components in front and rear, im installing with two amps, I need to rewire my car while im doing the sound dampening and im wondering if anyone knows which fasteners are used in the aveo's door and rug? as well as any other fasteners used in the counsol and panels on the sides??? Id rather have all those before i begin tearing everything apart since i will want everything put together asap. Please advise!



    2. #2
      Almost time to do my timing belt xintersecty's Avatar
      Join Date
      Sep 2010
      Location
      West Union, SC
      Posts
      1,687
      Thanks
      86
      Thanked 181 Times in 156 Posts
      I don't have pictures. Most fasteners will just pop and can be reused if treated properly.
      Please do not power off, firmware update pending.....

    3. The Following User Says Thank You to xintersecty For This Useful Post:

      tony_aveo05 (02-01-2016)

    4. #3
      Should I keep it?
      Join Date
      Dec 2015
      Location
      northlake il
      Posts
      34
      Garage empty: add car
      Thanks
      8
      Thanked 1 Time in 1 Post
      Quote Originally Posted by xintersecty View Post
      I don't have pictures. Most fasteners will just pop and can be reused if treated properly.

      Yeah i've reused car fasteners before, but being that theyre over ten years old, i was hoping to just replace them, specially that ive never dismantled these panels before, i can assume i will break a few.

    5. #4
      Almost time to do my timing belt xintersecty's Avatar
      Join Date
      Sep 2010
      Location
      West Union, SC
      Posts
      1,687
      Thanks
      86
      Thanked 181 Times in 156 Posts
      If I remember, I can take a few pictures tonight. This is a good question, where is a source for carpet and door fasteners? What does the pro use?

      I found this page and the prices are very much unreasonable. I have seen a good number of these exact fasteners on the Aveo.
      http://www.autozone.com/screws-pins-...panel-retainer

      I think you just need to pull the door and see what you got. Maybe this should become a sticky thread for the audio/interior section is a list of fasteners and sources with pictures.

      http://www.amazon.com/Front-Panel-Re.../dp/B0040CTYAQ
      Last edited by xintersecty; 02-01-2016 at 09:19 PM.
      Please do not power off, firmware update pending.....

    6. The Following User Says Thank You to xintersecty For This Useful Post:

      tony_aveo05 (02-02-2016)

    7. #5
      Should I keep it?
      Join Date
      Dec 2015
      Location
      northlake il
      Posts
      34
      Garage empty: add car
      Thanks
      8
      Thanked 1 Time in 1 Post
      Yeah thanks for the heads up, I will probably pop a panel and check the rug and see what i got under there. Ebay has cheap parts.

    8. #6
      Should I keep it?
      Join Date
      Dec 2015
      Location
      northlake il
      Posts
      34
      Garage empty: add car
      Thanks
      8
      Thanked 1 Time in 1 Post
      Quote Originally Posted by xintersecty View Post
      If I remember, I can take a few pictures tonight. This is a good question, where is a source for carpet and door fasteners? What does the pro use?

      I found this page and the prices are very much unreasonable. I have seen a good number of these exact fasteners on the Aveo.
      Interior Panel Retainer at AutoZone.com - Best Interior Panel Retainer Products for Cars, Trucks & SUVS

      I think you just need to pull the door and see what you got. Maybe this should become a sticky thread for the audio/interior section is a list of fasteners and sources with pictures.

      Robot Check

      When i do my audio build i will document everything. Should get a sticky up in no time

    9. #7
      Gotta do the SWAP!! krazy_85's Avatar
      Join Date
      Jan 2016
      Location
      Fort Collins, Colorado
      Posts
      38
      Thanks
      1
      Thanked 3 Times in 3 Posts
      I have basically stripped my aveo, the only thing I haven't taken out yet is the dash. the door panels, seats, front pillars, center console, center pillars for the front seat belts and all the lower panels are all easy to remove. the rear pillars with the quarter panel windows, that is where it can be a pain with the retaining clips. its been a while since i have stripped the car down doing audio, but if i remember correctly you have to pull a couple clips then slide the pillar towards the front of the car to remove it. after that you can remove hand grips then the headliner and carpet.

    10. The Following User Says Thank You to krazy_85 For This Useful Post:

      tony_aveo05 (04-01-2016)

    11. #8
      Should I keep it?
      Join Date
      Dec 2015
      Location
      northlake il
      Posts
      34
      Garage empty: add car
      Thanks
      8
      Thanked 1 Time in 1 Post
      Quote Originally Posted by krazy_85 View Post
      I have basically stripped my aveo, the only thing I haven't taken out yet is the dash. the door panels, seats, front pillars, center console, center pillars for the front seat belts and all the lower panels are all easy to remove. the rear pillars with the quarter panel windows, that is where it can be a pain with the retaining clips. its been a while since i have stripped the car down doing audio, but if i remember correctly you have to pull a couple clips then slide the pillar towards the front of the car to remove it. after that you can remove hand grips then the headliner and carpet.
      yeah thats exactly how i did it. looks and sounds great. i only broke one fastener after all that stuff i removed. the only thing i didnt take out was the ceiling liner and dashboard. took about 20 hours from start to end

    12. #9
      Gotta do the SWAP!! krazy_85's Avatar
      Join Date
      Jan 2016
      Location
      Fort Collins, Colorado
      Posts
      38
      Thanks
      1
      Thanked 3 Times in 3 Posts
      not bad. what are you running for your system?

    13. #10
      Should I keep it?
      Join Date
      Dec 2015
      Location
      northlake il
      Posts
      34
      Garage empty: add car
      Thanks
      8
      Thanked 1 Time in 1 Post
      Quote Originally Posted by krazy_85 View Post
      not bad. what are you running for your system?

      Pioneer GM-A5602 900W 2-Channel Class AB GM amp
      pioneer GM-D8601 mono amp

      Pioneer Stereo MVH-X560BT deck
      pioneer ts-m800pro 8" mid bass woofers for doors
      KICKER KST20 silk dome tweeters for pillars
      Pioneer TS-SW3002S4 1500 Watt 12" for the back with monster two amp kit for power





    Page 1 of 2 12 LastLast

    Similar Threads

    1. Audio and Gauges...
      By sflindall26 in forum Audio, Video & Interior
      Replies: 22
      Last Post: 02-19-2014, 11:52 PM
    2. Upgrading audio
      By arokace in forum Audio, Video & Interior
      Replies: 3
      Last Post: 03-10-2012, 05:00 PM
    3. Replies: 0
      Last Post: 12-04-2011, 01:18 PM
    4. Car Audio For Sale
      By thenixonyouth in forum For Sale / Wanted
      Replies: 15
      Last Post: 07-29-2009, 06:46 AM
    5. few more pics from audio install today
      By flaveo5 in forum Photographs and Videos
      Replies: 12
      Last Post: 07-17-2009, 03:32 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •