Wiring sub into stock connector

[Kyleellwood]

I decided i wanted a sub in my Aveo and took a look at the head unit to find all the pin-outs for a sub. There are no pins/wires in the holes though, How would I go about installing pins/wires into the stock head unit connector?

While i'm at it i might as well ask, if I do figure out how to get it looking all stock, do I need a line level converter for this? sub-out > amp > sub

This probably isn't an Aveo specific problem, maybe there is a how-to somewhere I can't find on how to do this.

[sbelcher]

Yes, you would want a inline converter that makes your speaker wire signals int RCA inputs so you can get sound to your subs, also for a remote you could run it to fuse that only works or comes on when thr car is on i.e : turn signal, headlights, or even the radio one. Good luck, hope i helped!

[sbelcher]

you can use scotchloc connects to tap into your speaker wire connections

[Kyleellwood]

[QUOTE=sbelcher;186161]Yes, you would want a inline converter that makes your speaker wire signals int RCA I want to avoid tapping into wires if i can, i want to install directly into the pin out