•  
    Results 1 to 4 of 4

    Thread: 2006 LT Front bearing question

    1. #1
      What's wrong with my car?
      Join Date
      Mar 2012
      Location
      Arkansas
      Posts
      3
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts

      2006 LT Front bearing question

      Hi everyone .

      I've got a 06 LT with a shot front left bearing. I went to the salvage yard today to pick a knuckle assembly, and out of the 3 they had pulled, all had some (about the same) play in the hub/bearing. Is this normal to have some up and down movement in the bearing assembly? All spun easily with no noise.

      Thanks in advance



    2. #2
      What's wrong with my car?
      Join Date
      Feb 2012
      Location
      Canada
      Posts
      8
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts

      Front bearing play

      When the drive shaft is put through the hub and then torqued, it preloads the bearing.
      This means that the hub assembly without the drive shaft can have some play even though the bearing is installed.
      The inner race of the bearing is actually two pieces which are sandwiched, and the bearing seated together once drive shaft is torqued.
      At least that's the case for my 05 aveo, yours should be the same.
      Hope this helps

    3. #3
      What's wrong with my car?
      Join Date
      Mar 2012
      Location
      Arkansas
      Posts
      3
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Good deal. That's what I was wondering. Thanks for the reply Ibro

    4. #4
      What's wrong with my car?
      Join Date
      Mar 2012
      Location
      Arkansas
      Posts
      3
      Garage empty: add car
      Thanks
      0
      Thanked 0 Times in 0 Posts
      Got her put together and torqued down and there is no slack in the bearing.

      TY again for the info.





    Similar Threads

    1. Got the front wheel bearing finished up today on my 2010
      By wylee in forum General Discussion
      Replies: 6
      Last Post: 09-18-2013, 05:45 AM
    2. How to replace the clutch and release bearing on a 2006
      By bigger daddy in forum Engine & Drivetrain
      Replies: 11
      Last Post: 07-17-2013, 08:03 PM
    3. Jeeze, tried changing front bearing today.
      By DailyDriverMark in forum General Discussion
      Replies: 15
      Last Post: 03-22-2013, 05:04 PM
    4. Replies: 3
      Last Post: 03-10-2012, 02:38 PM
    5. front bowtie/silver bar question
      By melficersx in forum How-To
      Replies: 3
      Last Post: 06-21-2008, 01:14 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •