2008 aveo 5 rear hub and bearing

I was wondering if anyone knew how the rear hub/bearing/drum went together on my 2008. I have read that on the older models the bearing was part of the drum. I have a bad noise coming from the left rear and believe it is the bearing. I did a little looking but wanted to be sure before I pull the wheel and get into it.

2008 Aveo5 - Rear hub and bearing

Removal & Installation

1. Before servicing the vehicle, refer to the precautions section.
2. Raise and suitably support the vehicle.
3. Remove the rear wheel speed sensor, if equipped.
4. Remove the wheel.
5. Remove the brake drum.
6. Unstake the caulking nut.
7. Remove the caulking nut.
8. Pull the wheel bearing and hub assembly straight off the spindle. The 2 inner wheel bearing races may not be secure.
   
   Attachment 8216
   
   
   To install:
   
   1. Slide the wheel bearing and hub assembly straight onto the spindle. Use care in order to properly position the wheel bearing races on the spindle.
   2. Install the caulking nut to the spindle and tighten to 140 ft. lbs. (190 Nm).
   3. Stake the caulking nut.
   4. Install the brake drum.
   5. Install the rear wheel speed sensor, if equipped.
   6. Install the wheel and tighten to 88 ft. lbs. (120 Nm).
   7. Lower the vehicle.
   
   
   

Thank you it went just that easy except when I got to the caulking nut. and realized I didn't have the right socket for the nut so off to the parts store.

Hey Mortman, just curious, what size socket was it?

It was an 1-1/4. Picked it up at Autozone for 8.99 in a deep, not impact but that's ok I don't think I need an impact for it.