•  
    Results 1 to 10 of 305

    Thread: Coilovers (crosspost)

    Hybrid View

    Previous Post Previous Post   Next Post Next Post
    1. #1
      Gotta do the SWAP!! krazy_85's Avatar
      Join Date
      Jan 2016
      Location
      Fort Collins, Colorado
      Posts
      38
      Thanks
      1
      Thanked 3 Times in 3 Posts
      Melveo, where did you get your springs? I finally installed my coilovers, but the ride is rough. Also how thick is the spacer your using? Thanks.

    2. #2
      The Lowest Static Aveo Melveo's Avatar
      Join Date
      Jan 2016
      Location
      Raleigh NC
      Posts
      256
      Thanks
      0
      Thanked 25 Times in 22 Posts
      Quote Originally Posted by krazy_85 View Post
      Melveo, where did you get your springs? I finally installed my coilovers, but the ride is rough. Also how thick is the spacer your using? Thanks.
      I bought rsk coilovers and basically street line for mk2. Yes the ride will be rough there's no weight on the rear end so it bounces a lot. I would take the bump stop out anywhere near maxed out. I swapped the rear with stance nation 326 springs at 8k so it's more comfortable but can still get out of hand, check on trans mount too,it could be destoryed by the bouncing. Just happened to me. Design quality -poor. Any pics of your car after leveling it.

    3. #3
      Gotta do the SWAP!! krazy_85's Avatar
      Join Date
      Jan 2016
      Location
      Fort Collins, Colorado
      Posts
      38
      Thanks
      1
      Thanked 3 Times in 3 Posts
      Thank you for the info. I have been searching for softer springs, but did not really know where to look. I still got to do some adjustments then I'll post some pics. Thanks again.

    4. #4
      Gotta do the SWAP!! krazy_85's Avatar
      Join Date
      Jan 2016
      Location
      Fort Collins, Colorado
      Posts
      38
      Thanks
      1
      Thanked 3 Times in 3 Posts
      Name:  thumb_IMG_0001_1024.jpg
Views: 886
Size:  98.1 KBI made the mistake of pulling the inner cv joint out while installing. after getting everything set, I put it in gear and no go. I got the bearings back in but once I tried for a test drive the cv joint disassembled again. Any suggestions, much appreciated.

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •