•  
    Results 1 to 2 of 2

    Thread: Grinding noise after changing drums/bearings several times

    1. #1
      What's wrong with my car?
      Join Date
      May 2017
      Location
      Canada
      Posts
      3
      Thanks
      1
      Thanked 0 Times in 0 Posts

      Grinding noise after changing drums/bearings several times

      I have a 2004 Chevy Aveo5. When I bought it, I had to replace the rear left drum as the bearings were falling apart. The drum was one of those hub and drum all in 1, so you had to unloosen the middle nut to change the pads and whatnot. After I changed it with an exact same one, maybe 3 weeks later the car started to made grinding/scraping noise whenever I turn right, I assumed it was the drum so I had it replaced with another new one and it seemed to solve the problem, for a while, another 4 weeks later that same noise came back and i replaced the drum another new one and again the noise is gone for about a month, noise came back again and I don't know what is causing it? Could it be that the drums that also have the hubs attached are cheap and don't last? Should I buy the setup that is hud and drum separate? What would cause my car to make this noise? Thanks.



    2. #2
      Almost time to do my timing belt
      Join Date
      Aug 2012
      Location
      Northeast
      Posts
      1,409
      Thanks
      3
      Thanked 103 Times in 94 Posts
      It's highly unlikely the parts are going bad after such a short period of time. There are lots of moving parts, and it's likely to be an installation or adjustment mistake. You need to get the wheel up in the air and try diagnosing the reason for the noise, and then you will have the answer and the resolution.



    3. The Following User Says Thank You to avguy For This Useful Post:

      MetroMPG (11-04-2017)

    Similar Threads

    1. Terrible grinding noise 06 Aveo
      By Ronnie62 in forum Wheels, Tires, Brakes & Suspension
      Replies: 1
      Last Post: 07-27-2016, 04:40 PM
    2. Grinding noise right after starting the engine??
      By christoff in forum Troubleshooting and Maintenance
      Replies: 9
      Last Post: 09-08-2014, 12:46 PM
    3. BADDD clunking/grinding noise when turning left or right while driving
      By karenpiechow in forum Troubleshooting and Maintenance
      Replies: 2
      Last Post: 03-14-2013, 08:12 AM
    4. Grinding noise
      By gotafish in forum General Discussion
      Replies: 4
      Last Post: 12-07-2011, 11:55 PM
    5. Grinding noise
      By Schwartz1986 in forum Troubleshooting and Maintenance
      Replies: 14
      Last Post: 08-30-2009, 01:47 AM

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •