Alarm, Remote and push button Start install

[Jkamper02]

Hey guys I’m needing help install this alarm. The problem I’m having is with the keyless door lock/unlock feature. Everything I’ve read says it’s a negative locking system so it should be just two quick wire splices but that’s not the case. If it is the case then I can’t find any diagram without conflicting color codes, so I can’t figure which wires should be used. Another question is does anyone know if I need any type of bypass for the alarm, this car doesn’t have PKIII and it has no coil around the ignition but it does chirp and flash, not sure if there’s a standard type or how to check. Thanks

[Eg.h2o]

https://www.the12volt.com/installbay...asp?tid=129924

2005-2006 Chevrolet Aveo Vehicle Wiring Chart and Diagram

[Bshoenbe]

I had the same probkem with the locks. I finally tied mine into the PKE module which I found after great difficulty to the left of the glove box. It was a simple 2 wire hookup. The problem that I'm having is where to connect to the start wire off the ignition. This car has computer controlled cranking and I want to use this start method with my remote start. I'm currently putting the start wire directly to the starter relay but this overides the neutral safety switch which I'm not keen on. If anyone has hooked up a remote starter on it runs off the ignition switch for cranking please let me know hiw. Thanks.