2010 Cruise Control

[fljohnboy]

Has anyone successfully added factory cruise to a 2009 or 2010? My dealer claims it can only be done up to 2008.

I installed an after market cruise in my 2009. It was easy, just 4 wire hook up.

[wylee]

I'm really hoping to avoid that route because I don't really like the stalk. I want either factory cruise or the switch specs so I can make my own switch to go in one of the blanks on the dash. Rostra will be my last resort.

[petrified.rabbit]

which 4 wires? would be the same wires for the factory switch i would think..

[4g63gst20]

My dealer was going to sell it to me at wholesale for $35. List is almost double that?

I have not looked elsewhere.

+1, I checked my stealership and they wanted ~$50.
For $35 I'd buy it. You should help a brotha out. Lol

[wylee]

which 4 wires? would be the same wires for the factory switch i would think..

The Rostra setup uses: 12 volt positive, ground, and the 2 factory cruise wires at the drivers knee panel. The knee panel wire color varies depending on the year. On the 09 & 10, the wires are gray and brown.

I heard back from Rostra & they got me set straight. There is an 8 prong plug on the RS of drivers compartment dash w/ 5 wires going in (grey, brown, green, blue & brn/wht) and 1 wire (blk) going out. Cruise 1 wire (Wht) went to the Grey & Cruise 2 (Grn) went to the Brown. Red to Ignition & blk to ground. Works like a charm.

[fljohnboy]

I still have the switch for sale on the classified side.

[Ratchet104]

I'm intrested...and I'm not sure if anyones done it on the newer Aveos yet....but according to the schematic for a 2010, the cruise control switch goes through the clock spring, and links into pins 30 (grey) and 31 (Brown) on connector x1 of the ipc, from there it communicates with the ECM using serial data lines

[The_Stig]

I'm taking the plunge on this....

I have a 2010 Aveo5 LS. Don't like the idea of adding an aftermarket unit to it. Figure it would be something for the dealership to use to deny any warranty work. So....

I got a steering wheel and column with cruise out of a junkyard for a 2009 Aveo.
I have to pull the steering wheel off of it. This is where it became a pain in the.....
.....there are no threads in the holes to use a steering wheel puller. I'm gonna have to modify something to remove it.

Anyone have any suggestions on how to post pictures here? When I work on it tomorrow I'll snap some pictures and kinda do a how to on installing it in the factory location.

[xintersecty]

the button will tell

[Ratchet104]

Unbolt the steering wheel bolt (behind the airbag) and just grab the steering wheel at 9 and 3 and rock it back and forth and pull towards you. it should give way