Do you have any clue of what I should do next?
Printable View
Do you have any clue of what I should do next?
Try this and learn how to use the tool and go back to my comment on what to measure.
https://www.youtube.com/watch?v=k2LgvmWNVwc
I just opened the switch itself and this is how it looks like from the inside.
I believe it may help.
Attachment 11334
As you said before, it seems it's a ground activated switch.
Pin 1 is for V_IN and pin 4 is Ground. No idea about pin 2 and 3. Guess one of them is light but don't know about the other one.
I measured the connector above my accelerator pedal with the car running (I disconnected the connector from the female) and this were my results:
Attachment 11335
As you can see, noone was 0 volts. No ground on that connector?
Any advise?
I read on another post that you could tap directly into the ECU. How would I do that?
Is this the ECU?Attachment 11336
Anyone can help me?
Anyone has any clue?
Is your car drive-by-wire or you have a throttle cable? If it is a cable system, how did you connected the throttle plate actuator? As far as I know, the only european drive-by-wire systems were 1,2 aveos.