I have seen a few posts on here of people asking how to remove interior door panel, and since there wasn't already one I decided to make a thread for those that don't know how to. I needed to fix my daughters exterior door handle as one of the bolts holding it down became loose. Anyways, here is my write up on a 2006 Hatchback model.

First off, there are 5 total philips screws to remove, a window crank, a door latch and round trim it. I have marked the locations of these screws in the pic below.
Name: IMG_2974_zps855f2214.jpg Views: 14345 Size: 54.0 KB

Use a flat head screwdriver to remove this rubber cover to expose screw behind it.
Name: IMG_2977_zps8c2748af.jpg Views: 7666 Size: 80.5 KB

Start from the top of this corner piece and pull, there are two clips that attach this trim to the door.
Name: IMG_2975_zpsb7863b66.jpg Views: 7877 Size: 40.7 KB

Once you removed the 5 screws, speaker trim and window crank, start pulling the door panel from the lower left corner to unsnap it free.
Name: IMG_2978_zpsc5b0f545.jpg Views: 7279 Size: 41.0 KB

Once you have the bottom free, lift the door panel up and out of the window trim.
Name: IMG_2979_zps40c5ad5e.jpg Views: 7239 Size: 42.8 KB

And this is what you'll end up with.
Name: IMG_2980_zps5d6edee2.jpg Views: 7745 Size: 51.0 KB

Once done, reinstall using these steps in reverse. The hardest part about putting it all back together is aligning the top of the door panel with the window seal.