Fog Lights Install

[Geo]

So I finally got all of my parts and began my oem fog light install on my '06 aveo hb. I started by removing the driver side wheel and then the plastic fender well liner. Then I removed half of the screws and bolts holding the bumper on to allow me to reach the plastic covers where the fog lights are going. I did not want to have to remove the entire bumper so this was very tight. But I managed to pull the plastic covers and install the new fogs with very little trouble. I repeated this process on the passenger side. I just started wiring them in with a universal harness and I'm going to run the on/ off cable to the new factory turn/headlight/high beam/ fog switch I bought as I wanted them to appear factory.

Nice man! I forgot all about this thread =[ I plan on installing fogs soon though =]

[sbelcher]

So you used a universal wiring harness and the factory turn signal arm switch where your headlights and high beams are right? How did you wire the harness to work with that turn signal arm?

[sbelcher]

The switch with the fog light on/off in it, i wanna buy it too and make it look factory but have no clue how to hook up the switch with a universal harness

[camopaint0707]

i have oem styles in mine, i wired the switch to a second 4 way hazard switch

[Sal_fresco]

So you used a universal wiring harness and the factory turn signal arm switch where your headlights and high beams are right? How did you wire the harness to work with that turn signal arm?

I had to purchase a new headlight combo switch that included the extra wire/ switch for the fog lamps. Then we connected the fog lights to an Un occupied fuse slot and ran the wire under the steering column to the switch. It has constant power so I have to remember to turn them off or I'll drain the battery, but they work great and again, look factory correct.

[sbelcher]

What wire did you run under the steering column? Maybe have a diagram of how you did this and maybe what wiring harness you used

[Jhelinski]

Where did you get the grille without the Chevy bowtie on it?

[Sal_fresco]

Where did you get the grille without the Chevy bowtie on it?

I made the grill out of my factory grill. I believe I posted a thread on the project if you look back at my past posts.

[Jhelinski]

Good looks! I'll have to search around for it! Thank you!

[Nickjwes]

Is it possible to take the fogs, wires, and column switch from an 08 LT sedan and put them in an LS sedan of the same year and maintain the ability to use the oem fog switch like stock?