How to disconnect Door Wiring harness?

[CrossTrek]

Hello!

I'm having some troubles with the audio and central lock on the driver side door. 3 months ago my door central lock left work when i press the button on the key or when i pull the lock. After a long seaching i realiced that if i press or move the wires that cross between the door and the cabin the central lock works...
Today the audio of the door started to fail so i tought that the wires are cut down too.
I took some photos, and thats it.. the wires are cuted, so i intented disconnect the harness but i couldn't.

Somebody had the same problem and know how to disconnect that conector?





Cheers!

[ChevyAveo2442]

If I recall correctly that plastic molding is clipped into the sheet metal and will have to by pried out. The connector should then be able to separate. This is how it was in my 2005 Aveo, sorry if this information is'nt correct but it should be worth a try. Good luck!

[CrossTrek]

If I recall correctly that plastic molding is clipped into the sheet metal and will have to by pried out. The connector should then be able to separate. This is how it was in my 2005 Aveo, sorry if this information is'nt correct but it should be worth a try. Good luck!

Thank you! I tried my best and took out almost all connector, but the space is too small and i couldn't disconnect it...
I found 2 wires cuted... i think that are of the central lock and about the audio i dont know what color is until disasemble the door and watch the color that come to speaker. I dont know what im going to do because is very small the place to work.. maybe from the inside of the door is much easier...

I'll keep it updated.

Cheers!

PD: Sorry if my english is not good or has some gramatical error, it is not my mother language

[CrossTrek]

Final Update: Hello!! After a long long fight that i lost xd trying to disconnect that connector into the sheet metal i decided to cut the plastic boot to access to the cutted wires, so there it were, 3 wires cutted : brown audio, gray and white central lock.
I had to cut the wrapping to release all wires and add new wire before weld them.
Also i had to remove the door stopper to have more space before work there.

So i added new wires and weld them with the old ones, after that i isolated the weld area with 3m vinyl tape and back to assembly the door...

It is not the most professional finish but works!

Some photos



Thank you very much for you help!!!
Cheers!