2009.. I had both front wheel bearings replaced but both rear ones are shot also. Can't afford the shop labor so I've ordered 2 wheel bearing hub assemblies from rock auto. Is it a fairly easy replacement? Any input would be greatly appreciated!!
2009.. I had both front wheel bearings replaced but both rear ones are shot also. Can't afford the shop labor so I've ordered 2 wheel bearing hub assemblies from rock auto. Is it a fairly easy replacement? Any input would be greatly appreciated!!
Last edited by bassman92552; 06-28-2014 at 01:35 AM.
yes should take about 15-20 min start to finish if you do not have air tools or a hoist . Do they come with the studs in? If not you can re use your old one if you do not mess them up, or you will have to buy new ones. A new set of studs is good to have if they been rusty and had lots of tire changes.( or rotating of tires ) For the next time because stud' can stretch/ wear out.
PONTIAC1976
PONTIAC
The Mark of a Great Car
PONTIAC
The Mark of a Great Car
This new set up is Messed up! at CarDomain. http://www.cardomain.com/ride/3101276
Hey thanx Pontiac. Yeah the new assemblies come with studs and bearings already pressed in. They were really reasobable, $81 with shipping. I do have air tools and electric impacts as well, so hopefully it won't be a problem.
Thanx again!!!